WOOD GLUE

Totally free of solvents, VOCs, formaldehyde etc.

Storage:
Protect from frost/freezing.

Where to use:
Interior woodwork, joinery, wooden floor tiles and laminates, floorboards, cork sheeting and tiles, etc.
Can also be used for paper, card, carpet, fabric, etc.
Not suitable for teak or other oily woods or asphalt-sealed surfaces.
Can be used on unsealed chipboard, hardboard, cement-screed and concrete substrates.

Preparation:
Ensure that the surfaces to be joined are clean, dry, non-dusty and free of oil and wax.
Previously varnished surfaces can also often be joined, but a thorough rub down with emery/glass paper is essential and a test area is advised.
Dusty concrete/cement floors may need to be sealed - ask for advice.

Application:

Flooring: Best applied to the substrate with a notching tool - ideally approx 0.01" (0.3mm) at 0.39" (10mm) centers.
Once spread, the adhesive should remain "wet" and workable for approximately 20 minutes but this does depend in part on the absorbency of the materials involved. If in doubt, a test area is advised. Only cover an area which can be finished within this timeframe. Press the floor covering firmly into place. Remove traces of wet adhesive with a damp cloth.

Joinery: Use as normal, apply with a brush or knife/spatula;preferably clamp until hard dry (min. 8 hrs). Remove excess with adamp cloth.

Avoid use in temperatures below 41°F (5°C), above 77°F (25°C), or in direct sunlight.

Coverage:
Varies considerably with the absorbency of the materials to be joined, but approximately 40 Sq Ft per Quart.

Health & Safety:
Avoid contact with skin and eyes. Wash off splashes with water. Keep out of reach of children.

ECOS Paints
PO Box 489, Fairforest, SC 29336
Phone: (864) 595-3840
Email: tech.help@ecospaints.net


Return to the Product Application Notes index page


The advice on this page is offered in good faith but does not constitute a specification and, as the conditions and techniques of application and use are beyond our control, no liability whatsoever will be accepted on our part for its use in full or in part. Always follow the instructions on the can. Follow preparation guidelines thoroughly - surfaces should always be clean, dry, sound and free of dust, efflorescence, grease, oil, rust, etc. The number of coats stated may sometimes seem to be onerous, but these are the ideal for best overall performance.




- -